LED Cimino Light Bulb Signal BAIT PRO LED Enhanced Up to 50% Brighter Version "PRO" as well as pointing to the small touches and loosening of the lens, in this version after the flashes the LED remains phosphorescently illuminated for a few minutes. You thought you missed a few mouthpieces while you were turning the "PRO" version aside from pointing to the small touches and loosening of the line, in this version after the flashes the LED remains phosphorescently illuminated for a few minutes. You thought you lost a few bubbles while you were Turning from shoulder to cane? Now also tells you the lost touches! Note: phosphorescence appears to be quickly fading in the video, this is due to the camera s sensitivity, it still remains visible even after 3 minutes of turning off the LED. It is advisable to mount the marker near the door, since the sensitivity will be greater and the probability that the wire when in the ban after launching will go laterally. With the help of the figures below we explain the simple operation of the bush: The peg is almost vertical, in the inclination all of us, inserting the barrel into the stack with that inclination the LED stays fixed on, Of the marker, the ball touching the poles of the 2 batteries closes the electrical contact. This condition, that is, with a solid lit LED, will also occur when the fish heading to the ground will drop the line by sending it to the ban. Adjusting the sensitivity: As you know, tensioning the wire, the bend flexes up to a point, then spinning will rise a bit, so using the same weight, your cymbal will always tilt that much. If the wire is still energized when the wire is energized, it means that you have to tilt the picket forward, forcing it into the sand, then restarting it. Adjust the tilt inclination until the LED goes out of power with the live wire. The inclination varies depending on the barrel stiffness and the lead weight you are using. By matching the inclination with which the LED has just switched off with the maximum voltage allowed by that lead, you will get the most sensitivity, in this condition it signals the 6-inches fish pits with more than 130 meters of water in the water. Inside the marker, the ball rolls open the electrical contact and the LED goes off, in this condition it is fishing, off, and with the utmost sensitivity. A 0.3 mm movement of the cim is sufficient in the direction of the wire to make it blink. (Any lateral vibrations generated by the wind do not make it blink because the electrical contact is located only at the front). In the figure above, increasing the inclination the ball will need a greater oscillation to touch the poles of the two batteries and to Flashing the LED, in this position the marker has a lesser sensitivity then in use with shaky sea. Considering that fishing remains off, it only flashes with the mouthpiece and in the launch and recovery stages, tested in the race, the batteries last up to about 120 hours of fishing. Mounting: The marker is removable for replacing the batteries and consists of 2 shells that couple one inside the other, a seal between the two shells making it waterproof, a screw secures the coupling. We have used high-grade materials to give a long life to the marker, we recommend the correct disposal of used packaging and spent batteries, we also remember that it is intended for adult use, as it is made up of small parts subject to ingestion by children . It comes with 2 extremely tapered supports, which do not hinder the launch, and allow quick mounting on the slim ledgering cymbals, ranging from 1.0 to 3.75-4.00 mm of split rods. The colored boxes, which also contain the two supports, in the direction of the ball have a small magnet that blocks the operation, allowing it to be carried in the pocket in any position.
This product was added to our catalog on Friday 26 May, 2017.